← All news

PlutoSky (Zynq 7020) firmware release and 1xBTS support

Open-source firmware that turns a Zynq 7020 PlutoSDR-class board into a timestamped, full-duplex Ethernet SDR, with new 1xBTS and 136BTS radio profiles.

Chris Moos

plutosky-stream is new open-source firmware for the PlutoSky, a PlutoSDR-class board with a Zynq 7020, an AD9363 and Gigabit Ethernet. It streams timestamped samples in both directions over Ethernet, and 1xBTS now ships a radio profile for it, so the board can run a 1x cell, an EV-DO carrier, or both.

About plutosky-stream

The stock PlutoSDR firmware streams samples through IIO and has no hardware timestamps, which is fine for receiving but not for a base station. plutosky-stream replaces the board’s FPGA design, kernel driver and userspace. The FPGA timestamps every sample with a 64-bit hardware clock, builds complete Ethernet frames directly in memory for the network controller to send, and buffers transmit samples until their precise transmit time.

The board runs both RF channels full duplex, from 70 MHz to 6 GHz. Sample rates go from 16.277 kS/s to 15.36 MS/s per channel, or up to 30.72 MS/s on channel 0 alone. Full duplex is sustained at 13 to 14 MS/s on one channel, and receive and transmit can run at different rates when they share a common multiple, for example 7.68 MS/s receive with 15.36 MS/s transmit.

On the host, plutosky-stream includes a SoapySDR module, so anything that speaks SoapySDR can open the board with driver=plutosky. Samples move as VITA 49.2 packets over UDP, and the board is controlled through a small gRPC service. Prebuilt SD card images are in the repository, so getting started means copying five files to a card.

Using it with 1xBTS

1xBTS uses the PlutoSky through its SoapySDR backend and runs 1x and EV-DO on it at the same time. The new config/radio_plutosky.json profile selects driver=plutosky, sets the antenna ports and gains, and includes the transmit-to-receive timing offset measured on the board, so access probes and traffic land where the receiver expects them. Point the BTS at it with --radio-config config/radio_plutosky.json, as the PlutoSky radio settings describe.

136BTS and GSM

136BTS, our IS-136 base station, runs on the PlutoSky too. It shares the same radio layer as 1xBTS, and uses the PlutoSky the same way, through SoapySDR, with its new config/plutosky.yaml. Build it with the soapy feature and pass that config with --run.

For GSM, the board has been tested with the Osmocom stack.

Getting started

Flash the SD card set from the plutosky-stream repository, build the SoapySDR module for your host, and check that SoapySDRUtil --find="driver=plutosky" finds the board. Then follow the getting-started guide with the PlutoSky radio profile in place of your current one.

The source is available on GitHub under the Apache-2.0 license, with the kernel patch under GPL-2.0.