← All news

umts-hnb: HSPA+ on an SDR with Osmocom

A UMTS (3G) Home NodeB running on an SDR, with voice, SMS, and HSPA+ packet data through an Osmocom core.

Chris Moos

umts-hnb is the newest of our open-source cellular projects, providing a UMTS (WCDMA) Home NodeB for SDR with voice calls, SMS, and packet data up to HSPA+ and dual-carrier HSPA.

UMTS is the 3G standard most GSM operators moved to in the 2000s, and the one that brought mobile broadband to phones through HSDPA and HSUPA. A Home NodeB is the small-cell form of a UMTS base station. Rather than connecting to an operator’s radio network controller, it connects to a core network over Iuh, the interface 3GPP defined for femtocells. umts-hnb implements the radio side and talks Iuh to an Osmocom core, while 1xBTS implements CDMA2000 and 136BTS implements IS-136.

Like 1xBTS and 136BTS, umts-hnb is written in Rust and uses sdr-hal for radio access.

Calls, SMS, and data

Phones attach with their own USIM, authenticate against the core, and get circuit-switched voice and SMS alongside packet data. Data runs on Rel99 dedicated channels or on HSDPA and HSUPA, including HSPA+ with 64QAM, and voice and data can be active on the same phone at the same time. Multiple phones can use the cell at once, and the radio link is ciphered and integrity-protected with UEA1/UEA2 and UIA1/UIA2.

On the core side, the Osmocom HNB-GW accepts the Iuh connection, the MSC handles calls and SMS, and the SGSN and GGSN provide packet data. The Osmocom core installation guide guides you through installing them from the Osmocom packages on Ubuntu, and the packaged configuration works with the HNB as is. The core can run on the HNB machine or on a separate one.

Radios

umts-hnb runs on an Ettus B200/B210, and on the PlutoSky R1 through the plutosky-stream firmware. Dual-carrier HSPA, which pairs two adjacent 5 MHz downlink carriers for one phone, works on the B200/B210 and is not yet stable on the PlutoSky. See the radio guide for the settings for each.

Getting started

Start with the core setup guide, which covers installing the core and adding your USIM to the HLR. The keys set on the subscriber record need to match the card, so a programmable USIM is the easiest way in. Then build and configure the HNB, set the cell’s channel and network identity to match the core, and start it. Once a phone attaches, try a call, an SMS, or a browser.

The source and documentation are available on GitHub under the AGPL-3.0 license.