Access Control
Closed access limits the network to subscribers in the HLR, on 1x and on EV-DO. A handset that is not a subscriber is refused at registration and cannot place calls, send SMS or start a data session. Open access, the default, serves every handset.
Enable closed access
Merge this into config/msc.local.json, then restart the MSC. For a combined stack, restart cdma-nib.
{ "access": { "mode": "closed" }}| Setting | Values | Default |
|---|---|---|
access.mode | open, closed | open |
access.register_policy | subscriber_only, any | subscriber_only |
register_policy applies in closed mode only. subscriber_only refuses the registration of a handset that is not a subscriber. any accepts it as Registration only, which keeps the handset camped without granting any service.
A change takes effect at each handset’s next registration, call or SMS. Calls and data sessions already in progress continue.
What each handset gets
The MSC assigns every handset an access class.
| Class | Handset | Registers | Calls and data | SMS |
|---|---|---|---|---|
| Admitted | Active subscriber matched by IMSI with ESN or MEID | Yes | Yes | Sends and receives |
| Limited | Suspended subscriber | Yes | No | Receives only |
| Provisioning | ESN or MEID matches an active subscriber, IMSI differs | Yes | *228 only | No |
| Registration only | Not a subscriber, with register_policy: "any" | Yes | No | No |
| Denied | Not a subscriber, disabled subscriber, or an ESN or MEID shared by more than one subscriber | No | No | No |
A refused registration sends the handset back to system selection. Most handsets look for another system and return after a power cycle or a roaming-list rescan.
When the HLR cannot be reached, closed access refuses the handset.
EV-DO
An EV-DO device reports no IMSI. The cell identifies it by its Hardware ID: an ESN, a MEID, or on many multimode handsets the first 14 digits of the IMEI. The cell matches the Hardware ID against each subscriber’s ESN, MEID and IMEI, and only a match to an active subscriber gets a data connection.
Add the IMEI for multimode handsets
Some multimode handsets report one MEID on 1x and their IMEI on EV-DO. Enter the full 15-digit IMEI in the subscriber’s IMEI field, alongside the MEID or ESN the handset uses on 1x. The field is optional, its check digit must be valid, and it is used only for EV-DO matching.
To find the value a handset reports on EV-DO, open its session on the HRPD Sessions page, or find its EV-DO row in the Access Denied & Provisioning panel.
OTASP
In closed mode, a handset whose MEID or ESN matches an active subscriber but reports a different IMSI registers as Provisioning. It can run OTASP, by dialing *228 or from the subscriber page, and nothing else. After the commit it reports the subscriber’s IMSI and is Admitted at its next registration. A pseudo-ESN, one starting with 80, is shared by many handsets and does not qualify on its own, so enter the MEID for those handsets. For a subscriber with an A-key, the handset must also authenticate before OTASP runs. See OTASP.